This was the sign-up page for the MegaSquirt EFI controller group purchase. This group purchase is closed - this is for informational purposes only.
For MegaSquirt purchases, see: http://www.megamanual.com/v22manual/mintro.htm#group.
Here is information on the MegaSquirt product deliverable:
The price for the above kit of parts is US$120.00 plus shipping each, provided that there are at least 100 units in the group purchase. If there are less than 100 units, then the price will have to be re-calculated based on the actual number of units (this situation is very unlikely to happen due to the large interest in the group purchase).Shipping cost is as follows:
Fill in your information to sign up to be emailed for notification of the MegaSquirt Group Purchase. This does not commit you to the group purchase, nor will we pass this information along to anyone else - we are only using this to notify individuals when the next group purchase is to occur. Please read the disclaimer below.
Disclaimer: This group purchase is for the components, PCB, and case for the MegaSquirt EFI controller. This unit is an experimental electronic fuel injector controller and not a commercial product. No warranties are expressed or implied. Neither Al Grippo nor Bruce Bowling are responsible for the construction, installation, or targeted use of this unit. This unit has been tested on several engines, however, it is an experimental unit and the end-user assumes all responsibilities for its use and application. Do not use in an aircraft which, if the unit fails or ceases to operate properly, can fall out of the sky. Do not use on a boat where, if there is a failure, results in a situation where the vessel is stuck in a hurricane and sinks to the bottom of the ocean. In other words, use common sense with this unit.